User Manual

Rev.03192021JA www.elitescreens.com U-00202 6
Edge Trim Installation
Step 9: Place the edge trim frame pieces over each end of the frame.
Connect edge trim frames (e/f) together using the M4 center joint (e) and secure with four of the M4x4 screws (m)
as show in Step 1. Repeat for other side.
Once both top and bottom edge trim frames have been connected, attach the vertical (left/right) sides edge trim
frames (d) using the elbow joints (f) and secure with four M4x4 screws (m) on all corners, Step 2.
Step 10: Install the angle cover (n) on each corner of the frame using the M4x4 screws (m).
Note: The angle cover screws holes align with the screw holes on the elbow joint.
1
1
2
2
2
2
f.
m
e.
m
.
n.
Tear off the double-sided tape.
ATTENTION: The back of the material has labels indicating the TOP and BOTTOM. The top edge trim piece with the
logo should be installed at the top. The material is directional and will not accurately reflect if bottom side is projected on.