User Manual

V072415-EA www.elitescreens.com 4
8. Make sure all four corners are properly in place to form a perfect square. Then fasten the four angles with
the M5x15 Screws (H).
Screen Material Installation
1. Lay the screen material completely flat with the front facing down on a clean surface in a horizontal position. The
back side of the screen material should be placed upwards.
Note: The back side of the material has the velcro borders all around the edges.
2. Carefully and gently place the assembled frame on top the screen material as shown below. Make sure to not allow
the angle edge of the frame to come in direct contact with the screen material to avoid puncturing it.
Four corners join correctly to form a perfect
square. Use the included screwdriver (L) to
fasten the Mx15 screws (H) into each corner
by aligning the frame screw holes to the holes
in the elbow joint (A).
Screen material back facing up
Velcro