37in Skylark-S Kit and PNP Versions Specifications Wingspan:37.4in (950mm) Length:40.
Dear Customer, Congratulations on your purchase of Skylark-S Kit from Value Hobby. We thank you for your generous support, and hope you enjoy your new airplane. At Value Hobby, we hope to offer competitive prices, good performance, and products that you can setup and use with ease. That’s why we extensively researched and tested this airplane, and suggested all the products necessary for you to setup properly.
Before Starting Assembly Unpack your airplane and examine the components. Check for damage of any kind. If you see any damage, please contact Value Hobby immediately. Airframe Parts 1. Fuselage 2. Left and right wing 3. Elevator 4. Vertical fin 5. Carbon fiber tube 6. PU tire 7.
8. Part bag 9. Propeller 10. Wheel housing RECOMMENDED EQUIPMENT Product SKU Quantity FrSky Taranis Q X7 Transmitter FRY-RC-5938 1 GForce Elite Series 2200mAh 3S LiPO FLM-LP-1874 1 Imax B6 Balance Charger w/ Power Supply IMX-CH-5458 1 GForce E450 Brushless Motor (2835-1200KV)* VHB-MT-5297 1 GForce 40A Brushless ESC* VHB-SC-4494 1 Towerpro SG90* TWP-SV-3214 4 *Required for kit version only. Not required for PNP version.
Secure the PU tire into wheel housing with landing gear wire. Then secure it with fixed wooden plate and screws. Insert main wing into the fuselage. Secure the wing on the fuselage with the rubber Oring. Install the assembled landing gear into the pre-cut slot on the bottom of fuselage. KIT version only: Secure control horn on the aileron with foam safe glue. Install Z-bend wire into the hole of the control horn. Connect control horn to the servo on the aileron.
KIT version only: Secure control horn on the elevator. Install Z-bend wire into the hole of clear control horn clip Connect control horn clip to the servo on the elevator. Clip the control horn into the control horn clip. Use some foam safe glue to secure the elevator into the pro-cut slots on the tail of fuselage Secure the rudder into the slot on the fuselage with foam safe glue KIT version only: Install Z-bend wire into the hole of clear control horn clip.
KIT version only: Locate a E450 size or similar brushless motor. Secure it into the fuselage with four screws. Connect your ESC to the battery. The CG should be 110mm (4.3-4.4in) from the leading edge of the wing. KIT version only: Connect 40A ESC to your motor.
