Specification

Cleaning the fan blades and motor
If necessary, clean the fan blades and motor with a soft cloth. If it is necessary to wash the fan blades,
cover the fan motor to prevent moisture damage.
Cleaning the interior of unit
When cleaning the cabinet interior, use a solvent of warm water and mild soap. Do not use steel wool,
caustic soap, abrasive cleaners, or bleach that may damage the stainless steel surface.
Cleaning the back panel:
1. Take down the setscrews of back panel one by one manually, and then take down the back panel.
2. Clean the backboard behind the panel by scour, pay attention to keep the safety of the heat
preservation material covered by the cupreous tube, clean the parts around the motherboard holes,
clean the back of the panel, and dry the cleaning parts using a soft cloth.
3. Fix the back panel on the cabinet after cleaning. Wash door gaskets on a regular basis, preferably
weekly. Simply remove door gasket from the frame of the door, soak in warm water and soap for thirty
(30) minutes, dry with soft cloth, and replace. Check door gaskets for proper seal after they are replaced.
WARNING — Disconnect power cord before cleaning any parts of the unit.
Replace the fluorescent lamp (for select models)
If replacement of the fluorescent lamp is required, disconnect the appliance from the power supply, take
the lamp holder away from the socket, and replace with a new and correct fluorescent lamp which the
correct specification. Refit the fluorescent lamp with the plastic pipe and lamp holder into the socket.
Then connect to power supply.
CAUTION — Servicing shall be done by Elite Kitchen Supply, Inc. authorized service personnel or
approved third-party repair technician, so as to minimize the risk of possible ignition due to incorrect
parts or improper service.