Specification

6. Maintenance: Please clean the unit with a lint-free cloth and non-corrosive cleaner. Before cleaning,
the unit must be unplugged. When the unit will not be used for a long time, disconnect the power cord
and then clean it. Please examine the wiring circuit before reusing it.
Restarting the refrigerator: Please wait 5 minutes to restart the refrigerator after the plug is pulled out
or sudden power failure, or it will reduce the lifespan of the compressor. To save energy, the refrigerator
door should not be frequently opened or left open for a long time.
7. Defrosting
Automatic defrosting: The electronic control panel is preset to automatically execute four defrosting
cycles within twenty-four hours. The timer will reset to the time or the initial start-up time. In order to
modify the start time for the defrost cycle to the desired time, it is sufficient to follow these directions,
press the defrosting button for six seconds, the unit will start defrosting at the time, and another cycle
will follow six hours later.
Manual defrosting: Press the button on the top right of the display of the electronic thermostat for six
seconds, the defrosting will start only if the sensor reveals a temperature that is inferior to a pre-set
value. In that phase, the defrosting pilot light and defrost LED will be switched on. The refrigerator coils
are defrosted by compressor stopping. The freezer coils are defrosted electrically.
CAUTION — Do not remove ice with a sharp metal instrument.
V. REGULAR MAINTENANCE
Cleaning the condenser coil
For efficient operation, it is important that the condenser surface be kept free of dust, dirt, and lint. Elite
Kitchen Supply, Inc. recommends cleaning the condenser coil and fins at least once per month. Clean
with a commercial condenser coil cleaner, available from any kitchen equipment retailer. Brush the
condenser fins from top to bottom, not from side to side. After cleaning, straighten any bent condenser
fins with a fin comb.