Specifications

P O W E R S UP P LY
Use the plug-in transformer (sold by Elite Access System only) by hooking it up
to 115V and use Two Conductor, low voltage, 14 gauge / 300 watt direct burial,
landscape lighting cables (part #A W-100 or A W-500). Connect these wires to
the two yellow wires from operator connector(J3), to the plug-in transformer.
Connect the battery cable to the harness connector from J1. The Timer LED will
blink 3 times. After the blinks, check the “charge ok” LED, it must be on.
Maximum length of wire should
not exceed 500 ft. If using more
than 500 feet, use 10AWG wire
up to 1000 feet.
Polarity does not matter.
To 115v
BACK TO TABLE OF CONTENTS