Specifications

C HO O S I N G MO V E M E N T D I R E C T I O N
Switch the “Open Inside / Open Outside” switch on the control board to the
corresponding position for the proper direction.
OPEN INSIDE
OPEN OUTSIDE
Set the sensor adjust-
ment so when the
gate hits any object
while opening, it will
stop and when the
gate hits any object
while closing, it will
reverse. Note: If you
activate the operator
and the gate stops in
the middle of the
driveway, the sensor is
set too sensitive.
The sensors must be adjusted while the
gate is in the opening or closing cycle.
OPTION - Stop by POS - STOP
This option is to be turned to yes if
the gate will use positive stops at the
close position.
IMPORTANT: It is necessary to still
adjust your limit switch at the close
position. The controller will look for
the limit close first and then it will
look for the positive stop.
SE N S OR A DJ U ST M E N T
St o p b y
P o s i t i v e
St o p O p t i on
BACK TO TABLE OF CONTENTS