Owner`s manual

315 MHZ RADIO RECEIVER PROGRAMMING

Setting Output Duration (M) or (C):

Changing output duration from

Momentary to Constant.

The receiver is factory set at (M) Momentary. To verify, refer to the label next to jumper P2. (See illustration below)

For commercial applications, the receiver can be set to either (C) constant or (M) momentary closure.

With the jumper in the (M) momentary position, the contacts will close for 1/4 second regardless of the length of remote control

transmission.

With the jumper in (C) constant position, the contacts will stay closed as long as the remote control continues transmitting. Push and

HOLD remote button to open or close gate.

To reduce the risk of SERIOUS INJURY

or DEATH from a moving gate:

• ALWAYS keep remote controls out of

reach of children. NEVER permit

children to operate, or play with

remote control.

• Activate gate ONLY when it can be

seen clearly, is properly adjusted, and

there are no obstructions in gate’s

path.

• ALWAYS keep gate in sight until

completely closed. NEVER permit

anyone to cross path of a moving

gate.

To AVOID damaging receiver, disconnect

receiver’s power before changing jumper.

To reduce the risk of SERIOUS INJURY or DEATH, the use of

CONSTANT OPERATION on residential operators is

PROHIBITED.

Programming Radio Receiver:

1. Press and release the “Learn” button on the receiver. The learn indicator light will

glow steadily for 30 seconds.

2. Within 30 seconds, press and hold the button on the hand-held remote. The operator

will now operate when the push button on the remote control is pressed.

Repeat Steps 1 and 2 for each remote control that will be used.

Erase ALL Remote Control Codes:

Press and hold the “Learn” button on the receiver panel until the indicator light turns

off (about 6 seconds). All previous codes are now erased. Reprogram each remote you

wish to use.

Radio Receiver

Antenna

Radio Receiver

Antenna

NOTE: Hand Held Remote

NOT Included.

CAUTION

WARNING