Owner`s manual

22
Wiring at #21 and #22 will be recognized as an Open Only command, and
Will Not close the gate.
To automatically Close the gate after an open cycle, the control board timer
must be turned ON. See page 26 about timer control.
Works as “Open Only” command.
Works as “3 Push Button” control.
To provide a Close command use #23 and #24.
Wiring at #23 and #24 will be recognized as a Three Push Button command.
The First command will open the gate.
The Second command will stop the gate.
The Third command will close the gate.
Strike Input #21 and #22
Input #23 and #24
Separate Power
for Device
Separate Power
for Device
Separate Power
for Device
WIRING ADDITIONAL INPUTS