Specifications

MAGLOCK ALARM
MADE IN USA
OPEN
INSIDE
STOP BY
POSITIVE
STOP
NO YES
OPEN
OUTSIDE
REVERSE
SENSOR
ALARM
SENSOR
ON
TIMER
POWER
REPLACE FUSE
WHEN LED IS ON
CHARGE OK
BAT LOW
CENTRAL
STRIKE
OPEN
SAFETY
LOOP
CENTER
LOOP
RADIO
REC
CONTROL
60 3
OFF
SYSTEM
ON
8A 125V
WARNING: FOR CONTINUED PROTECTION
AGAINST FIRE REPLACE ONLY WITH
SAME TYPE & VOLTAGE FUSE
2A 250V
1.5A 250V
WARNING: FOR CONTINUED PROTECTION AGAINST FIRE REPLACE ONLY WITH SAME TYPE & VOLTAGE FUSE
ACCESS SYSTEMS INCAC CES S S YS TEM S I NC
MAGLOCK ALARM
OPEN IN
OFF
POS STOP
ON
POS STOP
CLOSE DLY
ON
CLOSE DLY
OFF
OPEN OUT
REVERSE
SENSOR
MASTER SLAVE
ALARM
SENSOR
ON
TIMER
POWER
REPLACE FUSE
WHEN LED IS ON
CHARGE OK
BATTTERY LOW
CENTRAL
STRIKE
OPEN
SAFETY
LOOP
CENTER
LOOP
RADIO
REC
CONTROL
60 3
OFF
SYSTEM ON
WARNING: FOR CONTINUED PROTECTION
AGAINST FIRE REPLACE ONLY WITH
SAME TYPE & VOLTAGE FUSE
3A 250V
15A 250V
1.5A 250V
WARNING: FOR CONTINUED PROTECTION AGAINST FIRE REPLACE ONLY WITH SAME TYPE & VOLTAGE FUSE
TROUBLESHOOTING
Check the Fuses
If the gate is not moving in any direction be sure to check all of the LED displays on the control board. If the board
power or charging power LEDs are on, change the corresponding fuse on the right side of the board. If the motor
will not work, and all LED's on the board are ok, check the fuse on the left side of the board and replace if
necessary.
Master / Slave
Single
Caution: Replace the fuses only with specified rating (Supplied by Elite Access).
8 Amps
2 Amps 1.5 Amps
3 Amps 1.5 Amps
Change Fuse
15 Amps
Change Fuse
30
8A 125V
WARNING: FOR CONTINUED PROTECTION
AGAINST FIRE REPLACE ONLY WITH
SAME TYPE & VOLTAGE FUSE
REPLACE FUSE
WHEN LED IS ON
2A 250V
1.5A 250V
WARNING: FOR CONTINUED PROTECTION AGAINST FIRE REPLACE ONLY WITH SAME TYPE & VOLTAGE FUSE
REPLACE FUSE
WHEN LED IS ON
3A 250V
1.5A 250V
WARNING: FOR CONTINUED PROTECTION AGAINST FIRE REPLACE ONLY WITH SAME TYPE & VOLTAGE FUSE
WARNING: FOR CONTINUED PROTECTION
AGAINST FIRE REPLACE ONLY WITH
SAME TYPE & VOLTAGE FUSE
15A 250V