Specifications

......it must be “ON”.
After that, check the “Charge OK” LED......
If you see these LED's “ON”, replace fuse.
MAGLOCK ALARM
MADE IN USA
OPEN
INSIDE
STOP BY
POSITIVE
STOP
NO YES
OPEN
OUTSIDE
REVERSE
SENSOR
ALARM
SENSOR
ON
TIMER
POWER
REPLACE FUSE
WHEN LED IS ON
CHARGE OK
BAT LOW
CENTRAL
STRIKE
OPEN
SAFETY
LOOP
CENTER
LOOP
RADIO
REC
CONTROL
60 3
OFF
SYSTEM
ON
8A 125V
WARNING: FOR CONTINUED PROTECTION
AGAINST FIRE REPLACE ONLY WITH
SAME TYPE & VOLTAGE FUSE
2A 250V
1.5A 250V
WARNING: FOR CONTINUED PROTECTION AGAINST FIRE REPLACE ONLY WITH SAME TYPE & VOLTAGE FUSE
ACCESS SYSTEMS INCAC CES S S YS TEM S I NC
ON
TIMER
POWER
REPLACE FUSE
WHEN LED IS ON
BAT LOW
CENTRAL CONTROL
60 3
OFF
2A 250V
1.5A 250V
WARNING: FOR CONTINUED PROTECTION AGAINST FIRE REPLACE ONLY WITH SAME TYPE & VOLTAGE FUSE
1
6
1
5
1
4
1
3
12
1
1
1
0
9
8
7
6
5
4
3
2
1
J3 Plug
Connector
J3 PlugJ3 Plug
Control
Board
CONNECTING POWER SUPPLY
Connect the two yellow wires from the J3 plug connector to low voltage, direct burial landscape lighting cable, 14
gauge/300 watt not exceeding 500 ft, 10 AWG up to 1000 ft. Connect the lighting cables into Elite's plug-in
transformer 24 VAC (Included). Polarity does not matter. The transformer needs 115 VAC.
Polarity does not matter
Caution: The maximum length of wire should not exceed 500 ft.
If using more than 500 ft, use 10 AWG wire up to 1000 ft.
24 VAC
40 VA
14 Gauge Wires
Yellow Wires
#1, #2
To
115
VAC
After the transformer has been plugged into the power source, connect the battery cable plug
into the motor harness connector from the J1 plug. The “Timer” LED will flash “3 times”.
Battery
Cable Plug
Blink!
Blink!
Blink!
Motor Harness Connector
from the J1 Plug
17
Plug-in Transformer