Specifications

PROCEDURE FOR INSTALLATION
2.25" Vertical Height Difference
Step 4 (con't): The gate must be in the closed position. Make sure the operator is kept level while tack
welding the front and back steel brackets and reinforcement steel plates in position. After all tack welding is
finished, remove the operator!
Refer to Step 6
Caution: Welding the brackets with the operator attached to the gate may damage the operator.
Step 5: With the operator removed, completely weld around the brackets and plates on the gate.
Step 6: Remove the nut, bolt and bushing from
the back operator bracket. Place the metal bushing
in the hole of the steel bracket that will be used.
Secure operator with the nut and bolt (See Below).
Step 7: Remove the nut from the traveler carriage at
the front of the operator. Secure operator to the front
bracket with the washer and nut (See Below).
Metal
Bushing
Traveler
Carriage
Front Bracket
Back
Bracket
10
Mounting Instructions
Important:
Washer Must be
placed between
traveler carriage
and front bracket.
Important:
These nuts MUST be tight.
Refer to Step 7