User manual

Linux DVR System
④ When all setting is completed, move the cursor to the left side and exit from the
window using ◀ button among Direction Movement buttons.
9.4. Setup of Application Scope of Schedule
① When pressing ▼button among Direction Movement buttons once more, scope of
schedule can be set up.
② When yellow light is lit on Schedule Application Scope Menu, you can change to
‘Individual storage→ Entire storage’ using ▼ button among Direction Movement
buttons after moving cursor to setup window pressing ▶button again. Entire
storage means that you will change all camera setup as present setup.
③ Upon completion of all of the setup, get out of the schedule screen by pressing
ENTER button.
9.5. Movement from Schedule Setup Screen to Initial Menu Selection Screen of
SETUP MODE.
To move again to initial menu screen of SETUP MODE after all of the setup was
finished in schedule setup, press ENTER button or CANCEL button from the top
stage (designation stage of camera) of Schedule Setup Menu.
When the user presses CANCEL button from the top stage even if the user pressed
ENTER button from the lower stage, the new value set by the user is not stored and
the existing value is maintained.
① ENTER button means converting to initial menu screen
of SETUP MODE after storing newly set value.
② CANCEL button converting to initial menu
screen of SETUP MODE without storing
newly set value maintaining existing value.
LeadTech
９１