User manual

Linux DVR System
⑩ When Motion Continuance Time is completed, press ENTER button. Then, yellow
light on the rim of setup window is turned off and cursor in setup window also
disappears.
⑪ If the user does not use Overlay board in ELiSS LD-1600, the user can set up
Motion sphere DISPLAY ON/OFF. To set up Motion sphere DISPLAY ON/OF, move
cursor to Display by pressing ▶button among Direction Movement buttons. The
user can change ON/OFF using ▲/▼button among Direction Movement buttons.
⑫ If you press ENTER button or CANCEL button, you can go over to Setup Mode
Selection Initial-screen. If you press ENTER button, present setup value is stored
and transfer to Setup Mode Selection Initial-screen is done. But, if you press
CANCEL button, transfer to Setup Mode Initial-screen is done maintaining
previous value without storing present setup value.
⑬ Select Storage Schedule among Setup Mode Menu by moving cursor using
Direction Movement button (▲/▼/◀/▶button).
⑬ SETUP MODE – This allows you to set up motion storage time from Schedule, and
to Motion Sensing Sphere from – MOTION SPHERE SETUP.
LeadTech
８０