User manual

Linux DVR System
5.8. Setup of Motion
Set the storage status of camera setup to ‘Schedule’, and execute Motion Storage in
case when motion storage was set from Setup Mode – Schedule. Motion sensitivity
setup is the menu for the setup of degree of reaction when there is any motion in
setup sphere.
(Refer to Schedule in p.84: 9. SETUP MODE-Schedule.)
Its value can be set from 1 to 10 depending on the sensitivity, and 10 is most sensitive.
Basic setting is set to 6.
5.8.1. Setup of Motion Sensitivity
① Move the cursor to Motion Sensitivity Setup among Camera Setup Menu. For the
move of cursor, use ▲/▼button among Direction Movement buttons. ▲button moves
cursor to upper menu and ▼button moves cursor to lower menu.
② When ▶button among Direction Movement buttons is pressed, yellow color light is
lit around the rim of setup window which shows present setup value on the right
side of concerned menu, and the cursor appears in the first column.
③ Motion sensitivity setup can be set from 1 to 10. ▲/▼button among Direction
Movement buttons is used for the change of sensitivity. When pressing ▲button,
the number increases and when pressing ▼button, the number decreases.
④ After motion sensitivity setup is completed, when pressing ENTER button, yellow
light around the rim of setup window is turned off and the cursor inside setup
window disappears. When setup of Motion continuous time is intended, move
cursor to continuous time by pressing ▶button among Direction Movement
buttons.
LeadTech
７０