User manual

Linux DVR System
5.3. Changing Camera ID
User can change ID of camera at user’s own discretion to enable easy classification of
camera. Basic setup is set for ‘CAM+Camera No.
① Move cursor with ID among camera setup menu. ▲/▼button among Direction
Movement buttons is used for the move of camera. ▲button moves cursor with
upper menu and ▼button moves cursor with lower menu.
LeadTech
６５
② When ▶button among Direction Movement buttons is pressed, yellow light is lit
around the rim of setup window showing shows right side present setup value of
concerned menu, and cursor appears in first column.
③ Characters usable when changing camera ID are ⑴ English capital letter A~Z
⑵ Special symbols -
⑶ Blank character
⑷ Digits 0~9
Use ▲/▼button among Direction Movement buttons to change value of the
place where cursor is located. When pressing ▲button, change is made in the
order from English capital letter A to digit 9. When pressing ▼button, change is
made in reverse order of pressing ▼ from digit9 to English capital letter A.
④ If intended character is input in first column, move cursor to next column. To
move cursor to next column, press ▶button. To amend duly input character
during the input, move cursor to previous column. At this time, use ◀button for
the move of cursor.
⑤ Setup of camera ID can input up to maximum of 8 characters.
⑥ When input is completed, move menu selection window by pressing ENTER
button. Then, yellow light around the rim of setup window is turned off, and the
cursor inside setup window also disappears.