User manual

Linux DVR System
3.4. SEARCH MODE-JPEG BACKUP
JPEG Backup is a function to backup while search is made, and stores in picture file of
JPEG format by each 1 frame.
① Connect USB hard disk to USB Port.
② Execute General Search or Event Search. (Refer to p.: 3.2. General search. P. 3.3.
Event search).
③ Indicate the screen of the target camera as 1 channel mode by using camera number
from No. 1 to 16 located on the front side of ELiSS LD-1600.
④ If you press Regeneration (▶)button once again from the status in which searched
screen is being regenerated, it stops tentatively.
⑤ If you press right direction fast regeneration (▶▶)button from the status in which
searched screen regeneration stopped tentatively, proceed forward by 1 frame is
possible, and press BACKUP button when intended frame appears.
(Caution! ◀◀button does not proceed backward by each 1 frame.)
※ If pressing BACKUP button , frame of that moment appears as Stop Screen
and proceed Backup even in process of regeneration, not ‘Tentative Stop’.
⑥ If data is stored in USB Hard disk, then the message ‘Stored in USB hard disk’ appears.
In case it failed to store data, the message ‘Failed to store data in USB Hard disk’
appears.
⑦ Storage position of JPEG is under ‘/JPEG/’ directory, and stored in the name of same
type as ‘ch01_2003070112_3022.15.jpg’ (No. 1 camera 12:30 hours 22.15 seconds
July 1, 2003 frame).
LeadTech
３８