User manual

Linux DVR System
2.5. Automatic Channel Switching Function and TV OUT
Automatic Channel Switching Function is the function that automatically change
camera channel shown on the screen in case of screen divided into 13, screen divided into 9,
screen divided into 8, screen divided into 6, screen divided into 4 and Full screen. When
channel switching time interval is set up, camera channel on the screen automatically
changes at the set time interval. Time interval of channel switching can be set at the
discretion of user in setup mode.
(Refer to Channel Switching Setup and TV OUT on p.56: 4.4.)
When common analog TV is connected to TV OUT terminal at connection terminal in the
rear side of ELiSS LD-1600, same TV screen as the screen of ELiSS LD-1600 is output.
Setup of channel switching is equally applied to TV OUT screen.
2.6. Conversion of Camera Channel from DISPLAY MODE Screen
When a user presses any desired channel button in DISPLAY MODE by using 16 Camera
Select buttons located on the front side of EliSS LD-1600, such camera channel is directly
converted into Full screen so that the user may monitor the screen.
If you enter password, Camera Select button may be used as number-entering button. At the
time of password input, number 10 channel button is recognized as ‘0’.
If you press the desired camera
channel, the relevant camera
screen is converted into Full
screen mode so that you may
see.
2.7. Conversion of camera channel from DISPLAY MODE screen
This is a function to see the channel presently not shown in screen divided into 9/screen
divided into 8/screen divided into 4/Full screen mode. To convert camera channel shown on
the screen in EliSS LD-1600, use ▲/▼button among Direction Movement buttons. ▲button
increases (+) channel of the camera and ▼button decrease (-) channel of the camera.
Conversion of camera channel is impossible in case of screen divided into 13 and screen
divided into 6.
LeadTech
２２