User manual

Linux DVR System
12.4. Setup of Alarm Continuance Time
This is the menu to set up the time of ringing of alarm. Basic setting is set to 3
seconds.
① Move cursor to continuance time among Alarm Menu. Use ▲/▼button among
Direction Movement buttons for the move of cursor. ▲button moves cursor
upward and ▼button moves cursor downward. Yellow light is lit on the menu
where cursor is located.
② When ▶button among Direction Movement buttons is pressed, yellow light is lit
on the rim of setup window which shows present setup value on the right side of
the menu, and cursor appears in first column.
④ When alarm ringing time ends, move cursor to menu selection window by
pressing ENTER button Then blue light in selection window goes out and cursor
also disappears.
0.5
0.5
③ To change setup value, use ▲/▼button among
Direction Movement buttons. Pressing ▲button
increases the number and pressing ▼button
decreases the number
0.5
12.5. Movement to Menu Selection Initial-Screen of Setup Mode from Alarm Setup
Screen.
To return to initial menu screen of Setup Mode after finishing all setup in alarm setup
screen, press ENTER button or CANCEL button from the top stage (designation stage
of alarm) of Alarm Setup Menu.
LeadTech
１１１