User manual

Linux DVR System
12.3. Change of Setup in Alarm Menu
This is the menu to select the kind of alarm. Selection is possible between N/C
(Normally Close), N/O (Normally Open). Basic setting is set to N/O(Normally Open).
① After designating the alarm to change the setting, move cursor to Setup among
Alarm Menus. Use ◀/▶button among Direction Movement buttons for the move
of cursor. ◀button moves cursor to left direction and ▶button moves cursor to
right direction.
② When ▶button among Direction Movement buttons is pressed, yellow light is lit on
the rim of setup window which shows present setup value on the right side of
concerned menu.
③ Basic setup is N/O(Normally Open). When pressing ▲/▼button once, the setup is
changed to N/C (Normally close), and pressing ▲/▼button once again, the
value is changed to N/O(Normally Open).
LeadTech
１１０
▼ ▲
④ Upon completion of setup, move cursor to menu selection window by pressing
ENTER button. Then, yellow light around the rim of setup window goes out, and the
cursor also disappears.
N/O
N/O
N/O
1.1.1. N/O
N/O