User manual

Linux DVR System
12.2. Designation of Alarm to be Set up
② Designate the alarm by moving cursor. Use ▲/▼button among Direction
Movement buttons for the move of cursor. ▲button moves cursor to upper
direction and ▼button moves cursor to lower direction.
③ To change setting of concerned alarm after designating the alarm to change the
setup, use ◀/▶button among Direction Movement buttons. ◀button moves
cursor to left direction and ▶button moves cursor to right direction.
④ To move again to alarm designation menu from alarm menu, use ENTER button
or CANCEL button. When pressing ENTER button, transfers to alarm designation
window after storing presently set value. But, when pressing CANCEL button,
transfers to alarm designation window maintaining previous value without storing
presently set value.
① When entering to alarm setup screen from initial menu screen
of SETUP MODE, cursor is located at No. 1 Alarm (ALARM
01) among Alarm Designation Menu. Yellow light is lit on the
alarm on which the cursor is located.
LeadTech
１０９