User manual

Linux DVR System
11.4. Setup of Recording Continuance Time
When event happened to the sensor, the time to store the screen of camera must be
set. Basic setting is 3 seconds.
① Move the cursor to storage continuance time among sensor menu. ▲/▼button
among Direction Movement buttons is used for the move of cursor. ▲button
moves cursor to upper side and ▼button moves cursor to lower side. Yellow light
is lit on the position where cursor is located.
② When ▶button among Direction Movement buttons is pressed, blue light is lit on
the rim of setup window which shows present setup value on the right side of
concerned menu, and cursor appears in the first column.
④ Upon completion of the setup of storage continuance time, move cursor to menu
selection window by pressing ENTER button. Then, yellow light around the rim
of setup window goes out, and the cursor also disappears.
05
05
③ To change setup value, use ▲/▼button among
Direction Movement buttons. Pressing of ▲
button increases number and pressing of ▼
button decreases the number
05
LeadTech
１０４