User manual

Linux DVR System
11.2. Method of Designation of Sensor Intended to Set up
② Designate wanted sensor by moving cursor. Use ▲/▼button among Direction
Movement buttons for the move of sensor. ▲button moves cursor to upper
direction and ▼button moves cursor to lower direction.
① When entering to sensor setup screen after selecting
sensor at initial menu selection screen of SETUP
MODE, first cursor is located at No. 1 (SEN 01)
sensor among the sensors.. The sensor in which
cursor is located is lit with yellow light.
③ To change setup value after designating the sensor to set up, use ◀ / ▶button
among Direction Movement buttons. ◀button moves cursor to left side direction
and ▶button moves cursor to right side direction.
④ To move again to sensor designation menu from sensor menu, use ENTER button
or CANCEL button. When ENTER button is pressed, it transfers to sensor
designation window after storing present setup value. But, if pressing CANCEL
button it transfers to sensor designation window maintaining previous value
without storing present setup value.
LeadTech
１０２