Instruction Manual

7 8
Finding the Address
4. FINDING THE CAMERA’S IP ADDRESS
Use the steps below to find the camera’s IP address and connect to the
camera over the local area network
(LAN) using NVMS, UPnP on
Windows® 7, or Bonjour® in Mac OS®.
4.1 Finding the Camera’s IP Address Using NVMS
1. Install NVMS from the CD. Now Doubl e-click the NVMS icon ( ) on the
Desktop.
The l o g in screen appears.
2. Under User Name and
Password , enter the default NVMS user name
( admin ) and password ( admin ). Click Login.
Enter Admin
Enter Admin
Click Login
3.
NVMS opens and scans the l o c a l network for connected c a mer as.
Detected camera IP addresses on the LAN appear in the
Device List on
the
left side of the screen with a icon.
Found camera
IP address
6. If you need to adjust the
viewing angle,
l o osen the
6
screws on the sides of the
ball camera and adjust the
ball camera.
Do not remove
the
screws holding the ball
camera. Tighten the scr ews
when finished.
NOTE: Ensure the ball
c a mer a is point ed in thesame
direction as the IR LED t o
ensure a good nighttime
image.
Loosen screws to adjust the
angle of the ball camera
IR LED
Do not remove the screws
holding the ball camera.
7. Ensure the rubber gask et
inside the camera is
7
properly in place, then
replace the camera
c o v e r
and the camera cove r
screws (2x).
eLineTechnology.com