Instruction Manual

1 2
1. GETTING STARTED
The system comes with the following
components:
• 1 x Camera
• 1 x Mounting Screw Kit
• 1 x Allen Key
• 1 x RJ45 Coupler
• 1 x BNC Test Cable
• 1 x Mounting Template
• 1 x Quick Start Guide
• 1 x Instruction Manual
• 1 x Software/Documentation CD
Mounting Screw Kit:
• 2 x mounting screws
(PA4 30mm)
• 2 x drywall anchors
Allen Key
RJ45 Coupler
BNC Test Cable
1.1 Default Camera Username, Password, and Ports
Username: admin
Password: admin
Ports: 80
(HTTP), 30001 (Control/Streaming), 8080 (RTMP), 554 (RTSP)
IP Address:
DHCP Enabled by Default (Router will automatically assign IP
address)
NOTE: Once you have completed the basic setup of the camera, it is
r e c o mmended t o configure a static IP addr es s. This will pr ev ent the c a mer a
IP address changing in the event of a power failure. For details, see “6.7.1
Local Network” on page 26.
1.2 Camera Interior Overview
Mounting screw hole
Termination cables
BNC analog output
Status LED’s
microSD card slot (max. 64GB
supported;
SanDisk™/Kingston™ brand
memory cards recommended)
Reset button
IR LED
Mounting screw hole
CdS Light sensor
1.2.1 Functions of Status LED’s
• POWER (Top): Glows green when camera is connected to power.
• NET (Middle): Flashes red to indicate network activity.
eLineTechnology.com