Instruction Manual

43 44
Configuration
• Password: Enter the Password you have set on the account.
4. Click
OK to save settings.
6.12 Service Center
Service Center contains the following sub-menus:
• SMTP
• Alarm Center (not supported currently)
6.12.1 SMTP (Email Alert Setup)
The SMTP sub-menu allows you to configure email alerts when motion
alarms occur. Email alerts
will include a .jpg snapshot attachment.
Before setting up email alerts you must configure the following:
• Motion alarms must be enabled before the camera will send email alerts.
See “6.8.2 Motion Alarm” on page 32.
• A static IP address must be configured for the camera and DNS servers
must be entered.
See “6.7.1 Local Network” on page 24.
Configuration
4. Click OK . An error message appears if the masks configured exceed 8%
of the
t o t a l image area.
6.11 Network Service
Network Service contains the following sub-menus:
• DDNS
• PPPoE (Not supported)
6.11.1 DDNS
The DDNS sub-menu allows you to configure DDNS settings. Before
configuring
DDNS settings, you must register the camera for a free
DDNS account (see “5. Configuring Remote Connection” on page 10).
To configure DDNS settings:
1. Click Network
Servic e>DDNS .
2.
Check Enable DDNS.
3. Configure the
f o ll owing:
• Provider: Select DunDNS or 3322 ddns services as required.
• Domain Name: Enter the Domain Name for your registered account
with either service. This forms part of the prefix name on the domain.
NOTE: Connect to your camera using a web browser by entering http:// ,
the Domain Name , colon , and then the HTTP port. For example, if the
Domain Name is mycamera.dyndns.org, use the address
http://mycamera.dyndns.org :80 .
• User Name: Enter your User Name you registered as .
eLineTechnology