Instruction Manual

31 32
Configuration
To change the language for the OSD and email alarms:
1. Click
Device Configuration>Language.
2. Under
Language , select the desired language then click OK to save
changes.
6.8 Alarm Configuration
Alarm Configuration contains the following sub-menus:
• Disk Alarm
• Motion Alarm
• Alarm I/O (Not supported)
• I/O Alarm Linkage (Not supported)
• Alarm Setting (Not supported)
6.8.1 Disk Alarm
The Disk Alarm page allows you to configure alarms if there is an issue with
the recording disk. You can configure a Disk Full Alarm or a Disk Error
Alarm. A Disk Full Alarm triggers an alarm when the recording disk is full or
exceeds a certain percentage. A Disk Error Alarm triggers an alarm if there
is an error accessing or writing to the recording disk.
Alarms can be
viewed using the Alarm Manager in NVMS (see the
NVMS manual on the CD for details).
To configure Disk Alarms:
1. Click Alarm
Configuration>Disk Alarm.
2.
Check Disk Full Alarm to enable Disk Full Alarms.
Configuration
Configure microphone settings for listen-in audio. Self-powered
microphone required (not included).
To configure microphone settings:
1. Click
Device Configuration>Microphone.
2.
Check Enable Microphone to enable listen-in audio or un-check t o
disabl
e.
3. Under
Microphone Volume , select the volume for the micr ophone
between 1~100.
4. Click
OK to save changes.
6.7.7 BNC Video Output
Under BNC Output ( Device Configuration>BNC Ouput ), select On to enable
analog output or
Off to disable and click OK.
6.7.8 Language
Change the language for the camera OSD display (e.g. time and date display)
and email alarms. Supported languages are English, Polish,
Russian, and
Chinese.
eLineTechnology