Instruction Manual
25 26
Configuration
4. Click
OK
to
save changes. The
camera will
restart
with the new IP
address.
6.7.2 Device
Port
The Device
Port
page (
Device
Configuration>Device
Port) allows you to
configure the camera’s port configuration.
The
camera has the following
ports:
•
Control
port:
The
default is
30001.
Enables
video
streaming.
•
HTTP Port:
The
default is
80. Enables web access. Please
note that if the
HTTP
is port is anything other than
80, you
must enter http:// before the
camera’s
IP address and
colon
(:) and
the
HTTP
port after the
IP
address
when connecting using an Internet browser
(e.g.
if the
HTTP
port is 85,
enter http://192.168.x.x:85).
•
RTSP
Port: Default is
554. Only
used for special applications
requiring
RTSP
streaming, such as VLC player or quicktime movie.
•
RTMP
Port: Default is
8080. Only
used for special applications.
NOTE:
If you are configuring multiple IP cameras
for
individual
r
e
mot
e
access
(without an
NVR
or server),
you
must
change
all the ports
for
each
camera.
Two
cameras cannot use the same port number
.
To change camera
ports:
1. Configure the camera ports as required and then click OK.
2. Click
Device
Configuration>Device
Port.
Configuration
6.7.1 Local
Network
The
Local Network
page
shows the camera’s current IP address and
network parameters if
DHCP
is enabled. It also allows you to set a static IP
address for the camera
(see
below), set the networking parameters, and to
select
IPv4
or IPv6.
NOTE:
DHCP
is dis
abled by
default.
When DHCP
is
enabled,
the
IP
address
is shown under
DHCP
IP.
Use the IPScan tool on CD
to configure a static
IP address. This
will
prevent the camera IP address changing in the event
of a power
f
a
ilur
e.
To configure
the
camera’s networking
parameters:
1. Click
Device
Configuration>Local
Network.
2. Under IP
Protocol
,
select
IPv4
or
IPv6
.
If
you
would like to use
IPv6,
mak
e
sure it is supported on your network.
You
may need to contact
y
o
ur
network administrator or
ISP
for
details.
3. Select
Device obtain an
IP
address automatically
to use
DHCP
or Device
use
the
following
IP
address
to set a static IP address
for
the camera.
If
you are using a static IP address, configure the
f
o
ll
owing:
•
IP
Address:
Enter the IP address
you
would like to assign to the camera.
Make sure the IP address is available on your network.
•
Subnet Mask:
Enter the subnet mask.
•
Preferred
DNS
Server/Alternate
DNS
Server: Enter desired DNS
servers.
eLineTechnology