Instruction Manual
23 24
Configuration
•
Frame
Rate:
Select the frame rate for the stream up to maximum of
30FPS
for stream1 or stream2 or
12FPS
for stream3.
NOTE:
Frame rate ma
y
be a
utoma
t
ical
l
y
adjusted
to
ac
c
o
un
t
f
o
r
bandwidth
limitations.
•
I Frame interval: Select the interval for I frames: 1, 2, or 3.
The
default
value of 2 should be used unless there are special requirements.
The
I
Frame interval
does
not apply to stream3.
•
Bit Rate:
For stream1 or stream2, select
CBR
(Constant
Bit
Rate)
or VBR
(Variable
Bit
Rate).
Enter the desired bit rate below in
kbps.
Stream3 only
supports VBR.
•
Quality:
Select the
video
quality between 1 (lowest) and 9 (highest).
TIP:
A quality of 7 provides a
good
picture. It is not recommended to set a
high quality value with a small
VBR
bit rate.
3. Click
OK
to apply changes.
6.7
Device
Configuration
Device
Configuration contains the following sub-menus:
•
Local Network
•
Device
Port
•
Camera
•
Date & Time
•
OSD
•
Microphone
•
BNC Video
Output
•
Language
•
Multicast (Not supported)
•
Dome
PTZ
(Not supported)
Configuration
6.6
Stream
Configuration
The
Stream Configuration
page
allows you to configure the camera’s video
streams.
The
camera supports three different
video
streams. This allows
you
to
have a
high quality recording stream (stream1),
a
lower quality stream
(stream2) to preserve bandwidth for remote connections, and an MJPEG
stream for applications requiring MJPEG.
To configure video streaming
settings:
1. Click Stream
Configuration
.
Under Stream ID, select the stream you
would like to
c
o
nfigur
e.
2. Configure the
f
o
ll
owing:
•
Video Encode Type:
Select the
Video Encoding
type for the stream.
Stream1 and stream2 can be configured for
H.264 High
Profile, H.264
Main
Profile, or
H.264 Base
Profile. Stream3 supports
MJPEG
only.
•
Audio Encode Type:
Select the Audio
Encoding
type for the
stream:
G711_ALAW
,
G711_ULAW
,
or RAW_PCM.
•
Resolution:
Select the resolution for the stream. Stream1 and stream3
can
be
set to
1920x1080
or
640x360
. Stream2
can only
be
set to 640x360.
Stream3 can only be set to 1920x1080.
eLineTechnology