User Manual

33 34
CAMERA ADJUSTMENT CAMERA ADJUSTMENT
  ON:Makemotionareasvisible,OFF:Hidemotionareas
  ENABLEPressentertoaccessthe“deadbandsetting”
  screen,on-screencursormovesinresponsetothe
  inputsLeft,Right,UpandDowntosetthesensingarea,
  ordeadbandforspeciedblocks.Thisallowsyouto
  specifyandsetanareaofmotionwhichisnot
  rectangularinshape.
  PressandholdSETbutton3secondstoexit.
MOTIONAREA: ON/OFFEnable/DisableAreaNo.
AREASEL: 1/4/2/4/3/4/4/4.Selectsmotionareanumber.
TOP: SetthetopsideofthemonitoringframeselectedbytheAREASEL
 parameter.
BOTTOM: SetthebottomsideofthemonitoringframeselectedbytheAREA
 SELparameter
LEFT: SettheleftsideofthemonitoringframeselectedbytheAREASEL
 parameter.
RIGHT: SetstherightsideofthemonitoringframeselectedbytheAREASEL
 parameter
CAMERA ID OFF / ON
CameraIDshowsanameonthescreenaschosen.
CAMERA TITLE SETUP
CAMERA
ABCDEFGHIJKLMNOPQRSTUV
WXYZ0123456789-!#$%&’
()_`.:;<=> @^*./^*X+/
CHR1 CHR2
 CLR POS
RETURN

UseUp/Down/Left/Righttomovearound.CHR1/2changestheselectionfontsto
alternativeselection,CLRwillclearinfo.POSallowspositionchange.
LL
PHASE
326
RETURN

SYNC INT / LL 
 Videosynchronizationdisplayed
 INT(Internal)orLL(LineLock)
Note:ShowsINTwithDConlymodel.
 AndLLsettingforcameramodel
 whenconnectedtoaACsupply.
PHASE: 000-524
Adjustthephaseintheverticaldirectionwhentheline
lockmodeisavailable.
CAMERA RESET 
Thiswillresetallsettingsforallmenustomanufacturer
defaults.Thisallowyoutoreturntoshippedsettings
fromthemanufacturer.
EXIT / SAVE ALL
• EXIT ExitOSDmenu.
• SAVE ALL Savesthesettingstocamera
Refertothefollowingtableifyouareexperiencingtroublewithyourcamera.