LI27TA Ed.
GB
UK - Instruction on mounting and use Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Note: the elements marked with the symbol “ *)” are optional accessories supplied only with some models or elements to purchase, not supplied.
Installation without flue Installation with flue 1. 1. Use a pencil to mark the line representing the centre of the appliance on the wall, as far as the ceiling. This will make the installation process easier. 2. Position the drilling template on the wall: the vertical centre line printed on the template should be aligned with the centre line marked on the wall, and the lower edge of the template should line up with the lower edge of the cooker hood. 3.
Description of the hood Fig. 1 1. Control panel 2. Grease filter 3. Grease filter release handle 4. Halogen lamp 5. Vapour screen 6. Telescopic chimney 7. Air outlet used for filter version only) 8 . Panel Operation Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Control panel 1.
Grease filter Fig. 2 This must be cleaned once a month or when the filter saturation indication system – if envisaged on the model in possession – indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.
