EN Instruction on mounting and use
EN - Instruction on mounting and use Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The extractor hood has been designed exclusively for domestic use. The hood can look different to that illustrated in the drawings in this booklet. The instructions for use, maintenance and installation, however, remain the same.
Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange). Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Any responsibility in the matter is therefore declined. ! Use a duct of the minimum indispensible length. ! Use a duct with as few elbows as possible (maximum elbow angle: 90°). ! Avoid drastic changes in the duct cross-section.
Grease filter signal After 40 hours of operation LED 1 flashes. When such signal appears the grease filter installed needs to be washed. To reset the signal, keep T4 button pressed for 5”. The hood gives out a "BEEP" and LED 1 stops flashing. Charcoal filter signal After 160 hours of operation LED 2 flashes. When such signal appears the charcoal filter installed must be replaced. To reset the signal, keep T4 button pressed for 5”. The hood gives out a "BEEP" and LED 2 stops flashing.
