Installation Guide

15
Ifnotalreadydone,install1/2”conduitconnectorinjbox.
Attachtheverticalductcoversupportsusing4screws.
Place upper duct covers sliding through until spring
 sounds“click”.     
 Thenverify.
•
•
•
Place lower duct covers using one plastic bracket at
each vertex (4 needed).
Thelowerductcovershallbesecuredtorangehoodby4
screws.
Installthegreaselterandturnpoweronatservicepanel.
Check operation of the hood.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house
fuse blown.
Disconnect power supply. Check that wirin g is correct.
To get the most efcient use from your new range hood,
read the “Use and Care Information” section.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
•
•
•
•