Installation Guide

11
Attachtheverticalductcoversupportsusing4screws.
Place upper duct covers sliding through until spring
 sounds“click”.     
 Thenverify.
Place lower duct covers using one plastic bracket at
each vertex (4 needed).
•
•
•
Thelowerductcovershallbesecuredtorangehoodby4
screws.
Installthegreaselterandturnpoweronatservicepanel.
Check operation of the hood.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house
fuse blown.
Disconnect power supply. Check that wiring is correct.
Togetthemostefcientusefromyournewrangehood,
readthe“UseandCareInformation”section.
Keep your Installation Instructions and Use and Care
Guide close to range hood for easy reference.
•
•
•