Use and Care Manual

Mounting the hood

WARNING: 2 people are required to lift and position the

hood onto the mounting screws.

• Place the template on the wall along the horizontal line,

make sure the template is leveled and centered with the

centerline.

• Mark “upper” screw holes locations in the wall.

• IMPORTANT. Check to be sure that hole locations are

leveled and correctly centered by the vertical centerline.

• Drive “upper” wood screws by hand. Leave ¼ “ of

distance between the screw head and the wall.

• Remove the grease filter and mount the hood onto the

“upper” screws.

• Mark “lower” wood screw holes locations in the wall

using a pencil.

• Remove the hood.

• Drive “lower” wood screws, by hand. Remove screws.

• Mount the hood onto the “upper” screws.

• Drive and tighten the “upper” wood screws, by hand.

• Drive and tighten the “lower” wood screws, by hand.

• Install the plastic gasket to the front hood flange.