Specifications

DAILY WASHDOWN
Washdown after each sweeping shift is essential to
good sweeper maintenance. Follow the procedure
below for complete, effective cleaning.
1. Park the sweeper on a flat, level surface, away
from power lines, trees, etc.
WARNING
DO NOT work under or around a raised hop-
per. The best way to get safe access to the
machine behind the hopper is the roll-out
method described below.
2. Install a 1/2 x 2-1/2 inch bolt in each of the two
holes located above the spring-loaded door
latches on the sides of the hopper (Figure M-5).
The bolts will hold the hopper door closed dur-
ing roll-out.
DANGER
Raise or dump hopper in areas free of power
lines. Before raising or tilting hopper, check
for adequate overhead and forward clearance.
Raise hopper only in areas with minimum
overhead clearance of 16 ft (5 m) and forward
clearance of 3 ft (1 m). Do not raise hopper
while under trees, bridges, etc.
3. Raise and roll out the hopper using the Hopper
Dump Control on the Control Console (Figure
M-6).
!
!
M-7
MAINTENANCE
Locking Hopper Door For Roll-Out
Figure M-5