User guide

91
Pedestal
3. Press “+” on TracStar hand-held controller and hold for 3 seconds until unit begins deploying. (See Figure 3.)
Figure 3
4. Figure 4 shows the unit fully deployed.
Figure 4
Controller Operating Instructions
1. To activate system, turn on power to the TracStar Indoor Unit (IDU). The display should read "Ready".
2. Press the "+" key to begin satellite acquisition.
3. To stow the antenna, press and hold the "-" key for 3 seconds. To insure that transmit is disabled, there is a 3-
second delay before the antenna begins to stow.
4. The user may stop the motion by pressing the Start/Stop, + or - key at any time, either during an acquisition while
locked (Display reads "Run") or during a stowing operation (Display reads "Stow").
Complete operating instructions can be found in the TracStar Controller Operating Instructions included in the
Index of this manual.
READY: ( +UP -
DN)
IDLE SAT A @ 127