User guide

54
Description Action
Display
BLUE indicates default setting
Set Code (enables editing)
(Page 3.0)
From READY page
Main 2x
+ to code 13,
Enter
Main 2x
READY
TECH SETUP
Tech Setup CODE 13
Move/RF/Stow Safe Page
(Page 3.5)
From Ready Page:
Main 2x
Arrow 5x
Move [SAFE/ANY!] RF SAFE
EL 3.00 Stow EN
Move [SAFE] prevents azimuth axis motion
including jog commands below this pre-set
limit to prevent accidental mechanical
interference. Move [ANY] will disable the
SAFE mode.
+ or – then Enter Move [SAFE/ANY!] RF SAFE
EL 3.00 Stow EN
RF [SAFE] will inhibit LNB power thereby
inhibiting transmit if a motion command is
given to the antenna via the controller. RF
[ANY] will disable the SAFE mode.
+ or – then Enter Move SAFE RF [SAFE/ANY!]
EL 3.00 Stow EN
EL [X.XX] sets the low elevation angle for
Move SAFE. Adjust with + or – until the
desired value is reached.
+ or – then Enter Move SAFE RF SAFE
[EL 3.00/x.xx] Stow EN
Stow [En] is the auto stow feature designed to
stow the antenna in the event the GPS
systems detects more than 10 meters of
movement. This is a safety feature if the
antenna is roof mounted and the vehicle
begins to move with the antenna up. Stow
[DIS] will disable the safe feature.
+ or – then Enter Move SAFE RF SAFE
EL 3.00 Stow [EN/dis]
3.5 MOVE/RF_SAFE (con’t)
!! WARNING !!
“Stow EN” is NOT a failsafe
solution. Ultimate
responsibility falls upon the
user to ensure proper
antenna positioning prior to
movement of the vehicle.
For ultimate safety, users
should install an ignition
lock-out prohibiting
movement of the vehicle if
the antenna is deployed.
TracStar assumes no
responsibility for damage
to the vehicle or antenna
for failure to stow the
antenna.
IMPORTANT