User guide

53
3.5 Move/RF_SAFE
There are several safety features built into
the antenna:
 MOVE SAFE prevents any azimuth
motion including jog commands below
a pre-set elevation angle. This is to
prevent jogging the antenna at too low
of angles and possibility causing a
mechanical interference.
 RF SAFE provides a Transmit Inhibit
feature. If there is a motion command
given to the antenna while it is locked
onto a satellite, the transmitter will be
inhibited prior to any motion of the
antenna. The modem must have an
optional DC block installed in the
transmit line to be valid and for this
feature to be used.
 STOW EN will automatically stow the
antenna IF:
 Power is still present on the pedestal
 The GPS system detects movement of
more than ten (10) meters.
Requires approximately 45 seconds to
complete the STOW process. Power
MUST be present on the pedestal to
operate.
Move[SAFE] RF_SAFE
EL 3.00 Stow EN
2.0
User Setup
3.0
Tech Setup
3.1
Set Option
3.2
Set Test
3.3
Level/Motor
3.4
Modem/
Antenna
3.5
Move//RF
Safe
3.8
LNB
Gain
3.7
Geograph-ical
Area
3.6
Az Stow
4.0
Diagnostic
3.5
Move/RF
SAFE
Monitor
Check
Please
Wait
Loading
Please
Wait
PowerUp
Please
Wait
IMPORTANT
MoveSAFE RF_ SAFE
EL 3.00 STOW_EN