User guide

47
3.2 Set Test
There are several function available to the
user in Set Test. Press the
key to select the desired function.
NOTE: The following tests do not have
input parameters. They are either RUN or
NOT RUN as a standard factory setup
under the direction of factory personnel.
 NONE:
 SET PAZO: Sets pol axis azimuth offset –
(use when changing from factory reflector)
 MECH CAL: Mechanical self-calibration of
antenna
 USA REF SETUP – Clears out data and Ref
Sat locations and defaults to USAdvb
settings
 CLEAR REF DATA – Clears out all SAT / Ref
SAT data
 SCAN FREQ: Scans selected Reference
Satellites for transponder/carrier frequencies
that will be used in subsequent acquisitions.
 SCAN Sky: Scans the orbital arc for
Reference Satellite positions, signal strength
and frequency.
 EEP Save: Saves memory to NVEProm.
 SHOW MOVEs: Pre-programmed satellite
acquisition simulation.
SET TEST
[NONE]
1.0
Ready
Page
2.0
User
Setup
3.0
Tech
Setup
3.1
Set
Option
3.2
Set
Test
3.3
Level /
Motor
3.4
Modem /
Antenna
3.5
Move / RF
Safe
3.8
LNB
Gain
3.7
Geograph-ical
Area
3.6
Az Stow
4.0
Diagnostic
+
SET PAXO
MECH CAL
USA REF SETUP
CLEAR REF DATA
SCAN FREQ
SCAN Sky
EEP
SHOW MOVEs
3.2
Set Test
Monitor
Check
Please
Wait
Loading
Please
Wait
PowerUp
Please
Wait
SET TEST
NONE