User guide

23
1.1 Set Reference Satellite
 The antenna system uses a reference
satellite as part of the acquisition process.
 The Set Reference Satellite page allows
the user to select up to two pre-
programmed reference satellites from a
stored library.
 The RefX is the primary and the RefY is
the secondary. The secondary reference
satellite will be used in case the primary
satellite cannot be found, for example,
signal blockage.
 NOTE: Satellites located west of 0°
longitude are positive and those east of 0°
are shown as a negative number.
 1.3 Polarity is only viewable for the 1.2
and 1.8 Meter antennas.
 For best results, the REF satellite should
be low to the horizon and not overhead.
IMPORTANT
SetREF
Xd AUTO Yd 110.0Yd
1.0
Ready
Page
1.1
Set Ref
Satellite
1.2
Set Data
Satellite
1.4
GPS
1.5
Compass
1.3
Polarity
(See Note)
1.1
Set REF
Satellite
Monitor
Check
Please
Wait
Loading
Please
Wait
PowerUp
Please
Wait
SetREF
Xd AUTO Yd 110.0