User guide

20
1.0 READY PAGE
READY is the main or default page and
displays once the system is powered
up. It displays the selected satellite and
orbital position in degrees longitude
(positive degrees = West longitude; “-”
or negative degrees = East longitude).
 To activate the system: Turn on
power to the TracStar Power
Supply.
 To deploy: When READY displays,
press “+” and hold for 2 seconds to
initiate a satellite acquisition. (This
can be done with the antenna in
any position.)
 Press MAIN to navigate through the
main menu; press to navigate
horizontally through the display
pages; press ENTER to store a field
change or switch between fields on
a page.
 To stow: When READY displays,
press “–” and hold for 2 seconds to
stow. (This can be done with the
antenna in any position.) Lower
STOP LED should be on.
 From the READY page, press:
 to move to the Select
Satellite page.
 MAIN to move to User Setup.
Note that when the system is in READY
(standby) mode, the bottom green LED
(STOP) is on. When the system is
active, the top LED (START) is on.
1.1
Set Ref
Satellite
1.2
Set Data
Satellite
2.0
User Setup
2.1
Jog Page
3.0
Tech Setup
3.1
Set Option
2.2
Satellite
Parameter
2.3
Ref Sat
3.2
Set Test
3.3
Level/Motor
2.4
VS / Lock
3.4
Modem/
Antenna /
Polarity
3.5
Move/RF
Safe
3.8
LNB
Gain
3.7
Geograph-ical
Area
3.6
Az Stow
4.0
Diagnostic
4.A
Axis Angles
4.B
Factory
Only
4.C
Modem
4.D
Scan Hits
4.E
Tilt Angles
4.F
Position Data
4.G
GPS Data
4.H
Zero Resets
4.I
Offsets
4.J
Scan Width
1.3
GPS
1.4
Compass
4.K
SFE
SFR
Monitor
Check
Please Wait
4.L
azEr
4.M
elEr
4.N
plEr
4.O
Az>EncSF
4.P
Az>psf
4.Q
El>EncSF
4.R
El>psf
4.S
Pl>EncSF
4.T
Pl>psf
4.U
Axis –
Base Tilt
2.5
LST
Factory Only
Loading
Please Wait
Powerup
Please Wait
1.2 & 1.8M Motor
Drive Feed ONLY
1.3
POL
1.4
GPS
1.0
Ready Page
1.5
Compass
READY: ( +UP -DN)
IDLE SAT A @ 127