User guide

16
3. Quick Setup - From a Script
Step Function Action Display Page
1. Power up antenna Turn on power at ACU READY
2. Set Code (enables editing)
(Page 3.0)
From READY page
Main 2x
+ to code 13, ENTER
Main 2x
READY
TECH SETUP [Code 0]
Tech Setup [CODE 13]
READY
3. Clear existing satellite data.
(Page 3.2)
From READY page
Main 2x
Arrow 2x
+ or – to
ENTER
+
ENTER
READY
TECH SETUP [Code 13]
SET TEST, [NONE]
[CLEAR REF DATA]
[cancel]
[RUN NOW]
READY
4. Input reference satellite parameters
(Page 2.3)
Select Reference Satellite 1
Input orbital position for Ref 1
Input primary frequency for Ref1
Input secondary freq. for Ref1
Repeat, up to 12 Ref satellites
From READY page
Main 1x
Arrow 3x
ENTER
+ or – then ENTER
+ or – then ENTER
+ or – then ENTER
+ or – then ENTER
READY
USER SETUP
[Rs 1]
[XXX.X]
[XXXXX]
[XXXXX]
[Rs2]
5. (Input reference satellites
Page 1.1)
Select RefX satellite
Select RefY satellite
From READY page:
Arrow 1x
+ or – then ENTER
+ or – then ENTER
READY
Set Ref
XXX.X
XXX..X
6. Input data satellite parameters.
(Page 1.2)
Toggle between SatA and SatB
Input orbital position for SatA
Input orbital position for SatB
From READY page
Arrow 2x
+ or – then Enter
+ or – then Enter
+ or – then Enter
READY
SELECT DATA
[SatA] or [SatB]
XXX.X
XXX.X
NOTE: Locate the antenna
so that it has an
unobstructed view of the
orbital arc.
Orient the antenna so that
it comes up generally to
the south (if located north
of equator), north (if
located south of equator).
IMPORTANT