Owner`s manual

http://www.elfinx.com

Alarm Memory Mode

If more than two chirps are heard or lights flash more than 2 times when disarming the system, it indicates

that the system was triggered in user's absence. The system will report the status as below:

 3 chirp sounds and lights flash 3 times → indicate the shock sensor was triggered

 4 chirp sounds and lights flash 4 times → indicate the doors were opened

Press once, the system will report the triggered memory status again. The triggered memory status

will be removed after any of the doors is opened.

NOTE: If silent alarm mode is on, only the lights will flash.

Arming Reminder (Short JP3)

When turn the vehicle engine off and close the door for 10 seconds, the alarm will siren ‘Beep Beep Beep Beep’ 4

times and also flashing the lights 4 times that is arming reminder.

P.S.

By open the JP3, it will turn the Arming Reminder off.

Electronic / Air Compressor Lock Interchange

Short JP2: Electronic Lock Status

Open JP2: Air Compressor Lock Status

Remote Control Code Cancellation and Installation

The security code stored in the remote and the main unit can be changed following the procedures listed

below:

Remote Control Code Cancellation

1. When in disarming mode, close the doors. Apply and keep on the brake. Then open the door (now,

vehicle’s lights are flashing).

2. Turn the ignition key from OFF to ON position 5 times within 10 seconds and keep the key in OFF

position (now vehicle’s lights stay on). After 3 seconds, siren will beep 3 to indicate that the security

code is cleared from the system.

Remote Control Code Installation

When in disarming mode, close the doors. Apply and keep on the brake. Then open the door (now,

vehicle’s lights are flashing). Turn the ignition key from OFF to ON position 3 times within 5 seconds

and keep the key in ON position (now vehicle’s lights stay on). Then press any key on remote control.

Siren will beep 3 times to indicate that the security code has store in the system.

P.S.

Repeat to store another remote control (this system support 4 remote controls)