FSK-6000 Two Way Car Security System OWNER’S MANUAL CONTENTS: OPERATING INSTRUCTIONS DESCRIPTION OF FUNCTIONS AND FEATURES WIRE CONNECTION GUIDE INSTALLATION GUIDE Information to the user http://www.elfinx.
This operation manual details the use of the device contained in the package. It is recommended to look for an experienced technician for device installation. Warning Changes or modifications not expressly approved by the manufacturer will void the warranty and the user’s authority to operate the device. This device complies with Radio Frequency Rules in respective countries. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2.
System Installation Guide Main Unit Installation The main unit is placed under the vehicle control panel. After fixing the main unit in a suitable place, start connecting all the wiring according to the Wire Connection Diagram. Before putting back all the OEM parts, simply test the system functions first. The main unit must be fixing tight Shock Sensor Installation Install the shock sensor after fixing the main unit.
Central Lock Installation Guide Nowadays, vehicle’s central lock system has around 10 different types and this system can control several common central lock systems without any additional parts. Here are 6 connection types: Type A: For vehicles equipped with central lock, a central lock first recommendation (FIG. 1) Type B: For vehicles equipped with central lock but no motor on driver’s side, add a master motor and rod into the driver side door. (FIG.
Remote Control Operation Active Pager Operations on Remote This DUAL-LINK paging remote keeps you in control with instant signals and actions in response to events threatening your vehicle. 1. Arming When all doors are closed, press button to arm the vehicle and lock the doors. The siren then chirps once and the lights flash once. After about 8 seconds, the LED starts flashing.
7. Emergency Alert (Panic) At any time, press of the remote control, the siren then sounds and the lights flash for about 30 seconds. To turn it off, press again. NOTE: This function can be used for car finding in a large parking lot. 8. Turning Off Alarm Sound When the system is triggered, press , , or button to turn off the warning sound from the remote control and the alarm sound from the vehicle. NOTE: under Emgergency Alert, only can turn off the alarm sound 9.
Alarm Memory Mode If more than two chirps are heard or lights flash more than 2 times when disarming the system, it indicates that the system was triggered in user' s absence. The system will report the status as below: 3 chirp sounds and lights flash 3 times → indicate the shock sensor was triggered 4 chirp sounds and lights flash 4 times → indicate the doors were opened Press once, the system will report the triggered memory status again.
Specification Main Unit Output Current: Signal Lights 5A x 2, Siren 2A, Central Lock 10A Coding: Learning code Voltage: 12V +/- 2V Static Current: <12mA (except indicator, sensor) Indicator Current: 20mA Shock Sensor Current: 4mA Frequency: 433.92MHz Remote Control Voltage: 1.5V Static Current: <0.8mA Battery: 1 x AAA 1.5V (Alkaline) Frequency: 433.92 MHz Trouble Shooting The alarm keeps sounding and cannot be stopped by the remote control. Check the wiring connection.
Check the battery level in the remote control. (It is suggested to replace the alkaline battery each month) Check if the remote control has been damaged physically or by liquids. If possible use another remote control for comparison. If both of them do not work, then check the wiring connection. (Do not open the main unit for checking) Check if the main unit code match with the remote control code. The central lock does not work. Check if the actuators are working. Check the wiring connection.
