Operating instructions

L-10 DIGITAL ELF CLONE PROGRAMMER OPERATING INSTRUCTIONS
TO ENTER A PIN NUMBER TO RESTRICT ACCESS TO THE SET-UP MENU
When the PIN number feature is activated, to access the L-10D DIGITAL ELF Set-up Menu turn the power to the L-10D DIGITAL
ELF TV on. Press the Set-up key on the IR Remote followed by the 4 digit pin number. The Set-up Menu will then appear.
To cancel the requirement for a pin number to access the Set-up Menu follow the instructions below and enter a PIN number of
0,0,0,0.
1. Connect L-10D DIGITAL ELF Programmer to the telephone jack that exits the swivel assembly. After several seconds
the Programmer Menu will appear on the screen.
Note: The programmer will turn the TV on if it is off when the programmer is connected.
2. Once the L-10D DIGITAL ELF Programmer Menu appears press the F2 button on the IR Remote to access the PIN Number
entry screen. Using the numeric keypad on the L-10D DIGITAL ELF IR Remote enter a 4 digit pin number. Press F4 to save
the PIN number or F1 to exit without changing the PIN number. In either case the Menu screen will now be displayed. If no
other actions are desired press the POWER button on either the TV or the infrared hand unit to reset the TV and restore
normal operation.
3. Note: If the user decides not to either load from or to a TV once the Programmer Menu screen is displayed then the
user should use the POWER button on the TV or infrared hand unit while the Menu screen is displayed. If the
programmer is disconnected while the Menu is being displayed the TV will have to have power removed and
reapplied to restore proper operation.
3. Disconnect the L-10D DIGITAL ELF Programmer from the TV.
IF YOU ENCOUNTER PROBLEMS
If the Programmer does not operate as described above then some problem may have been encountered. In this case the RED indicator
will be illuminated and the YELLOW indicator can be used to determine the recommended corrective action. Refer to the table below
for information on the meaning of the YELLOW indicator.
Yellow on steady:
Some difficulty communicating with the TV has been encountered. The problems is probably transitory and may not
happen again. Disconnect and reconnect the Programmer then try the desired action again. If the problem persists
then try the programmer on a second TV. If the problems is present on a second TV then it is likely the programmer
is at fault and needs to be sent for repair. Please attach a description of what action could not be accomplished.
Yellow flashes once repeating every two seconds.
The TV is set for COMPUTER MODE OFF. Refer to the L-10D Operators Manual and set the COMPUTER
MODE to ON.
Yellow flashes twice repeating every two seconds.
The pre-sets image stored in the Programmer is corrupt or not valid. This can happen if there was a problem while
uploading the information from the reference TV or if the Programmer was disconnected prior to completing the
upload. Reload the pre-sets from the reference TV.
Yellow flashes three times repeating every two seconds.
The pre-sets image stored in the Programmer is not compatible with the requirements of the TV it is connected to.
Firmware revisions sometimes makes data incompatible with the prior or future versions. The format of the stored
data must match the requirements of the TV it is to be loaded to. To allow for this possibility the data format of the
stored pre-sets and TV requirements are checked for compatibility and the Programmer prevents incompatible data
from being loaded to a TV. This means that the firmware in the TV is different from the reference TV from which
the pre-sets were uploaded. If this condition occurs either the TV needs to have it's firmware changed to match the
reference TV or an new pre-sets image must be loaded to the Programmer from a TV which is compatible with the
one which is desired to be downloaded to.