MULTI-NETWORK CABLE TESTER MODEL TCT-355 (MT-7051) Elenco® Electronics, Inc. 150 Carpenter Avenue Wheeling, IL 60090 (847) 541-3800 Website: www.elenco.com e-mail: elenco@elenco.com Instruction Manual Elenco® Electronics, Inc. Copyright © 2008 Elenco® Electronics, Inc.
ITEMS INCLUDED WITH MODEL TCT-355 Cable Tester Remote MAINTENANCE GENERAL MAINTENANCE To clean, wipe the case with a damp cloth and detergent (do not use abrasives or solvents). When the power LED does not light when the unit is switched on, you need to replace the battery. The terminator does not use a battery. BATTERY REPLACEMENT The tester is powered by a single standard or alkaline 9V battery. Use the following procedure to replace the battery. 1. Disconnect the cables from the tester. 2.
WIRING SCHEMES INTRODUCTION The TCT-355 Cable Tester is a convenient instrument for testing different shielded/unshielded wiring schemed communication cable with RJ-11 and RJ-45 connectors and coax cable. This tester can be used for testing cables before and/or after they are installed. Testing status is indicated by multiple LEDs. Soft vinyl case provides storage for the tester, remote and terminator.
OPERATION INSTRUCTIONS Warning: 1. Caution: Do not connect the cable tester to live circuits as it may be damaged by over voltage. Configuration for Testing Coaxial Cable Terminator LED 2. Turn on the TCT-355. If the power light ( O ) does not light, please replace the 9V battery with a new one. 3. When testing communication cable with RJ11 connectors, use only the RJ11 jacks on the tester and remote. How to Use the TCT-355: 1.