User Manual

Contents

1. Safety Information 3

2. Introduction 4

3. Features 5

4. Specifications 5

4-1 General Specifications 5

4-2 Measurement Specifications 6, 7

5. Operation 8

5-1

Preparation and Caution before Measurement

5-2 Front Panel Description 8, 9

5-3 How to Make Measurements 10-13

6. Maintenance 14

6-1 Battery Replacement 14

6-2 Fuse Replacement 15

6-2. Fuse Replacement

This meter is provided with a 200mA/250V 5 x 20mm

fuse to protect 200μA, 2000μA, 20mA, 200mA ranges.

NOTE: The 10A circuit is not fused.

1. Turn off the power.

2. Remove the two screws from the back of the case.

3. Remove the fuse from the holder and replace it with a

new fuse of the specified value.

Fuse Numbers

• 200mA/250V 5 x 20mm Bussman Fuse #GMA 200

• 200mA/250V 5 x 20mm Little Fuse #235-200

• 200mA/250V 5 x 20mm Elenco

Fuse #530020

WARNING

PLEASE READ THIS INSTRUCTION

MANUAL CAREFULLY!

Misuse and/or abuse of this instruction cannot be

prevented by any printed word and may cause injury

and/or equipment damage.

Please follow all these instructions and measurement

procedures faithfully, and adhere to all standard

industrial safety rules and practices.

-2-

-15-

CAUTION

Failure to turn off the DMM before installing

the battery could result in damage to the meter

if the battery is connected to the battery

terminal incorrectly.

` `