Instruction manual

-6-
PC BOARD ASSEMBLY
Solder the following parts to the PC board.
R6 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R3 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R7 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R2 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R8 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R4 - 560W 5% ½W Resistor
(green-blue-brown-gold)
(see Figure A)
R9 - 120W 5% ½W Resistor
(brown-red-brown-gold)
(see Figure A)
R1 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
R5 - 680W 5% ½W Resistor
(blue-gray-brown-gold)
(see Figure A)
8 Wire Cable with RJ-45 Plug
(see Figure B)
4 Wire Cable with RJ-11 Plug
(see Figure C)
Figure A
Mount the resistor flat against
the PC board as shown. Solder
and cut off the excess leads.
Figure B
1
8
1 - Blue
2 - Orange
3 - Black
4 - Red
5 - Green
6 - Yellow
7 - Brown
8 - Gray
1. Insert the cable with
RJ-45 plug into the
hole in the PC board
as shown, noting the
direction of the plug.
2. Insert the eight colored
wires into the corresponding
holes in the PC board as
shown.
3. Tug the cable down to the
position shown.
4. Turn the PC board
over. Solder the wires
and cut off the excess
leads.
Plug
PC Board
Solder Side