Instruction manual

-21-
SECTION G - FINAL ASSEMBLY OF TESTER
Push the button cap onto the switch as shown in Figure O.
Mount the PC board to the top case, as shown in
Figure P, with two #4 5/16” phillips screws.
Note: The button cap should be centered in the
top case hole. Make sure that the Lo Batt LED
goes through the hole in the case.
Wrap the wires from the battery snap around the
battery housing as shown in Figure Q.
Mount the bottom case to the front case, as
shown in Figure Q, using four 3 x 12mm flat
phillips screws. Be sure that the battery snap is
through the battery compartment hole as shown.
Connect the 9V battery to the battery snap and
place it into the case. Slide the battery cover
onto the case as shown in Figure R.
Figure O
Figure P Figure R
#4 5/16” Screws
PC Board
Top Case
Battery Cover
9V Battery
Button Cap
Bottom Case
3 x 12mm Screws
Figure Q